Mobility Screen
Foti has a neutral spine position in his athletic stance. He created anterior and posterior tilt but did show vibration goin into posterior tilt. This is likely a sign of lower back or lower abdominal control or strength issues. He did pass both the torso and pelvic disassociation screen. Foti was limited in his primary and secondary squat screen. He was also limited (1”) on each ankle in his ankle dorsiflexion screen. Foti was limited in his scapular palpation screen and also showed 4” of scapular retraction. These combined screens show there may be disconnection issues present in the load and launch phase. Foti has minimal hip mobility in both hips. This should be noted in how he sets up his lower half.
Force Plate Swings
Foti uses a ball of foot load and advance in his rear foot. This can be seen in his video as the heel comes off the ground and the back leg goes into extension in the advance. His overall force and rate of force production are below average. Increasing this and connecting up the turn will increase bat speeds and reduce time to impact.
KVEST Sequencing & Rotational Speeds
Foti hits in a 1-2-3-4 sequence. His turn speeds and gains are within a good range. He does rotate from -18.75 degrees at first move to 104.78 degrees a contact. This is higher than we’d like to see for overall rotation . Deceleration of segments is average and can be improved. Deceleration is at a slow rate, which should be improved to keep cutting down time to impact and overall speed transfer.
Bat Sensor Data
Foti has a low rotational acceleration which is indicative of a disconnected swing or longer bat arc. This is also seen in his time to impact, which was .17 seconds. Attack angles were slightly higher than pitch angle at 17 degrees.
Movement Prep
- Sit-up position posterior tilt – start in sit-up position with your hand under your lower back. There will be a natural tilt of the pelvis into anterior position. From here begin the sit-up while trying to feel your lumbar spine press firmly into your hand. Once you feel this sensation you will return to original position. Next try to create the same sensation without raising your shoulders or hips off the ground.
- Hands and knees anterior/posterior tilt – start on hands and knees (knees under hips). Create anterior and posterior tilt using as little thoracic movement as possible.
- Hands and knees single arm anterior/posterior tilt – start on hands and knees (knees under hips) and bring one hand to your chest. Create anterior and posterior tilt using as little thoracic movement as possible. Repeat with the opposite hand on chest.
- Standing hands on knees anterior/posterior tilt – start with hands on knees (athletic position). Create anterior and posterior tilt with as little thoracic movement as possible.
- Standing single arm anterior/posterior tilt – start with one hand on a knee and the other on your chest (athletic position). Create anterior and posterior tilt with as little thoracic movement as possible. Repeat with opposite hand placement.
- Dead bug progression – start on back with knees and hips bent at 90 degrees (you should feel your entire spine connected to the ground – if not bend slightly more from the hips). Elevate arms so the wrists and elbows are directly above the shoulder (towards the sky). Extend one leg away without the spine coming off the ground (the pelvis will want to go anterior and lift the lumbar spine). Reset and repeat with the other leg.
- J-band reverse fly’s – attach j-bands to both wrists. Start with anchor point facing the chest. Pull arms rearward by retracting the scapulas together. Maintain a neutral spine position. Hold at the retracted position for a 5 count and then return to the front (5 count coming forward as well – as the scapulas slowly move away from the spine and work off the rib cage.
- J-band bent arm pulls – attach j-bands to both wrists. Start with anchor point facing chest. Arms start bent at 90 degrees. Pull the elbows rearward as you retract the scapulas towards the spine. Maintain a neutral spine position. Return back to 90 degree position. Repeat as you change anchor point height and adjust posture accordingly.
- Single arm j-band arm pull – attach j-band to the back side wrist. Start with anchor point facing chest. Arm starts at 90 degrees. Pull elbow rearward while lead arm stays relaxed. Keep rib cage as stabile as possible. Return back to starting point. Repeat as you change anchor point and adjust posture accordingly.
- Single arm j-band body turn – attach j-band to the back side wrist. Hold arm at 90 degrees. Rotate body in the normal swing direction. Make sure the wrist doesn’t move as the scapula is retracted by the turn of the torso. Return back to starting point. Repeat as you change anchor point and adjust posture accordingly.
- Single arm, j-band back resisted turn – attach j-band to wrist. Anchor point will be off the side of the body (back shoulder). Start with arm at 90 degrees. Turn torso away from anchor while resisting wrist movement away from body (supination is fine). You may feel external shoulder rotation. Repeat as you change anchor point and adjust posture accordingly.
- Bar resisted turns – attach bands to the end of a clipped bar. Anchor point will be off the side of the body (back shoulder). Start in hitting position with one hand on upper and lower part of bar. Resisted top clip of the bar. Turn torso in the swing direction. Resist wrist movement. You will also feel external shoulder rotation (think the bar is turning to perpendicular to spine. Repeat as you change anchor point and adjust posture accordingly.
Swing Prep
- Movement prep work based off screening and video assessment.
- PVC full swing (hear the most amount of wind off the PVC)
- PVC 180 degree swing – use a split grip on PVC (about two fist lengths). Create as much wind as possible while not going past 180 degrees of a turn. There will be rear elbow disconnect from the body line, but not across the belly button. Repeat from different postures (different pitch heights). Repeat to different layouts (opposite field, center, pull side).
- PVC 90 degree swing – use a split grip on the PVC (about two fist lengths). Create as much wind as possible without disconnecting rear elbow from rear hip. Repeat from different postures (different pitch heights). Repeat to different layouts (opposite field, center, pull side).
- Full bat swings (fastest bat speed)
- Bat 180 degrees swings on a tee – use split grip (about one fist length). Create as much much speed as possible without going past 180 degrees of a turn. There should be no wrist roll on the finish. There will be rear elbow disconnect from the rear hip (but not across belly button). Repeat from different postures (different pitch heights). Repeat to different layouts (opposite field, center, pull side).
- Bat 90 degree swings on a tee – use split grip (about one fist length). Create as much speed as possible without disconnecting rear elbow from rear hip. Repeat from different postures (different pitch heights). Repeat to different layouts (opposite field, center, pull side).
- Bat 180 degree swing on a flip or short overhand – use split grip (about one fist length). Create as much much speed as possible without going past 180 degrees of a turn. There should be no wrist roll on the finish. There will be rear elbow disconnect from the rear hip (but not across belly button). Repeat from different postures (different pitch heights). Repeat to different layouts (opposite field, center, pull side).
- Bat 90 degree swing on a flip or short overhand – use split grip (about one fist length). Create as much speed as possible without disconnecting rear elbow from rear hip. Repeat from different postures (different pitch heights). Repeat to different layouts (opposite field, center, pull side).
- Rotational medicine ball throws – start in stance with medicine ball around rear ribcage/abdomen. Stride and throw medicine ball with focus on staying in posture. Repeat from multiple hitting postures (different pitch heights) and different directionality (opposite field, center, pull side).
- Cross body medicine ball throws – start in a cross body stance (lead leg stride across the direction of the throw). Full speed throw trying to maintain feet spacing. Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side)
- Rotational medicine ball throws with constraint – start in stance with medicine ball around the rear ribcage/abdomen. Stride and throw medicine ball with focus on staying in posture. Block lead leg from opening while thinking lead pocket should turn as little as possible. Repeat from multiple hitting postures (different pitch heights) and different directionality (opposite field, center, pull side).
- Cross stride start full swing – start with rear foot two feet behind front foot in normal launch position. No additional stride, slight counter turn and then swing. Try to maintain spacing between feet. Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- Normal stance cross stride full swing – start in normal stance, stride closed (about two feet). Full swing trying to maintain feet spacing. Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- No feet neutral stance full swing – start in neutral launch position. No additional stride, slight counter turn and then swing. Feet stay anchored throughout the swing (back foot may slide rearward but stay flat on ground). Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- Normal stance/stride no feet full swing – start in normal stance and take normal stride. Go right into swing without the feet coming off the ground (back foot may slide rearward, but stays on the ground). Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- Full swing limited hip turn – normal stance and stride. Normal swing trying to have the least amount of hip turn to get to full speed and best ball strike. Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- Full swing limited torso turn – normal stance and stride. Normal swing trying to have the least amount of torso turn needed to get to full speed and best ball strike. Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- Banded resistance swings – banded resistance to the lead hip (belt). Normal swings with thought of resisting the band from pulling you forward in the turn. Band resistance can be altered as necessary. Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- One leg kettlebell squat w/slide disc – start on back foot with kettle bell front racked. Front foot will have a slide disc under it. Squat with normal pattern with emphasis on feeling heel centric load, while allowing lead foot to slide out.
- One leg kettlebell jump squat – start on back foot with kettle bell front racked. Squat with normal pattern and then jump off the ground. Stabilize with a soft landing as you go back into squatting position. Feel the heel impact and create pressure against the ground.
- Back foot disc anchors – start with a disc under the ball of the foot of the rear shoe. Heel of the rear shoe should be anchored to the ground. Stride away from the back foot while keeping it anchored in the ground.
- Both feet disc anchors – start with both balls of feet on the slide disc. The heel of both feet should be off the discs. Stride forward by sliding the lead slide disc forward (you should be on the ball of foot only. The rear shoe will stay anchored in the heel and the lead side will slide free. As you get to end of stride length begin to turn the pelvis/hips. The lead foot should now anchor the heel which will stop the slide forward. Back side will likely spin or kickback off of disc.
- No feet neutral stance full swing – start in neutral launch position. No additional stride, slight counter turn and then swing. Feet stay anchored throughout the swing (back foot may slide rearward but stay flat on ground). Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- Normal stance/stride no feet full swing – start in normal stance and take normal stride. Go right into swing without the feet coming off the ground (back foot may slide rearward, but stays on the ground). Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).
- Banded resistance swings – banded resistance to the lead hip (belt). Normal swings with thought of resisting the band from pulling you forward in the turn. Band resistance can be altered as necessary. Repeat to different postures (pitch heights) and directionality (opposite field, center, pull side).